Adafruit ESP32-S2 TFT Feather – 4MB Flash, 2MB PSRAM, STEMMA QT

REGULAR PRICE: £36.06

This fits your .
• by entering your model number.
• This feather comes with native USB and 4 MB flash + 2 MB of PSRAM, so it is perfect for use with CircuitPython or Arduino with low-cost WiFi
• ESP32-S2 240MHz Tensilica processor – the next generation of ESP32, now with native USB so it can act like a keyboard/mouse, MIDI device, disk drive, etc!
• The ESP32-S2 is a highly-integrated, low-power, 2.4 GHz Wi-Fi System-on-Chip (SoC) solution that now has built-in native USB as well as some other interesting new technologies like Time of Flight distance measurements.
• The colour TFT is connected to the SPI pins, and uses additional pins for control that are not exposed to the breakout pads.
• Fast shipping from our UK store

Product description

This is an ESP32-S2 Feather board with a built in IPS TFT color display. It’s got all the features of a Feather main board, the comforting warmth of an ESP32-S2 WiFi microcontroller, and a 240×135 pixel color TFT display. All that and it will even plug in nicely into a breadboard, terminal block wing, or Feather Doubler or even just stack on top of another wing.

• ESP32-S2 240MHz Tensilica processor – the next generation of ESP32, now with native USB so it can act like a keyboard/mouse, MIDI device, disk drive, etc!
• Mini module – FCC/CE certification and comes with 4 MByte of Flash and 2 MByte of PSRAM – you can have huge data buffers
• Color 1.14″ IPS TFT with 240×135 pixels – bright and colorful display with ST7789 chipset that can be viewed at any angle angle.
• Power options – USB type C or Lipoly battery
• Built-in battery charging – when powered over USB-C
• LiPoly battery monitor – LC709203 chip actively monitors your battery for voltage and state of charge / percentage reporting over I2C
• Reset and DFU (BOOT0) buttons – to get into the ROM bootloader (which is a USB serial port so you don’t need a separate cable!)
• Serial debug output pin – (optional, for checking the hardware serial debug console)
• STEMMA QT connector for I2C devices – with switchable power, so you can go into low power mode.
• On/Charge/User LEDs + status NeoPixel – with pin-controlled power for low power usage
• Low Power friendly! – In deep sleep mode we can get down to 80~100uA of current draw from the Lipoly connection.
• Compatiblity – works with Arduino or CircuitPython