Gasoline Water Pump 1 inch Dirty Water Pump 1.7HP 38cc 4 Stroke Petrol Engine

Gasoline Water Pump 1 inch Dirty Water Pump 1.7HP 38cc 4 Stroke Petrol Engine Portable Garden Pump 8000 L/h for Lawn Irrigation, Swimming Pool

• 👍【PREMIUM ENGINE】 Powered by a 4-stroke 33 cc gasoline engine, this gasoline dirty water pump runs extremely stably with a strong power of up to 1.25kW (1.7HP) and a speed of 8500 rpm, laying a good foundation for efficient work.
• 👍【HIGH EFFICIENCY】 The gasoline dirty water garden pump adopts a new design, with higher efficiency, the maximum flow rate of the petrol water pump reaches 8000 l/h, the maximum lift reaches 30m, and the maximum suction lift reaches 7m.
• 👍【BEST DURABILITY】 This petrol engine dirty water pump uses high quality alloys to make pumps and impellers with high strength and durability. In addition, the strong metal frame also provides good protection and stability for the pump.
• 👍【EASY OPERATION】 The water inlet and outlet of the gasoline irrigation pump are all connected with a 1 inch thread, which is very easy to assemble, and the gasoline pool pump is started by recoil, which makes it easy to start.
• 👍【WIDE APPLICATION】 This gasoline garden water pump can be used for irrigation of agriculture, gardens, lawns, etc. This petrol water transfer pump is also suitable for pumping dirty water from basements, etc. after heavy rains or floods.

Description:

Wp 10-140f Portable Pump Is Suitable for Garden Lawn Watering, Field Pumping, Drainage Operations, Clothing Crops, Green Seedlings, Irrigation and Fertilization, Etc.

Parameters:

Model: Wp 10-140f

Engine Model: 140f-3

Engine Type: Single-cylinder, Air-cooled,Four-stroke Gasoline Engine.

Engine Displacement: 38cc

Maximum Power and Speed: 1.2kw, 8500r/Min

Fuel Tank Volume: 650ml

Engine Oil Tank Volume: 80ml

Maximum Suction: 7m

Maximum Lift: 30m

Inlet: 1” (25mm)

Outlet: 1” (25mm)

Flow Rate: 8000l/H

Gross/Net Weight: 10kg/8.2kg

Packing Size: 38x35x30cm/14.96*11.81*13.78in

Product Size: 36*28*32cm/14.17*11.02*12.60in

Start Mode: Pull Start

Features:

Low Fuel Consumption, Stable Performance, Long Service Life and Low Failure Rate

High Speed, Parallel Conveying>100m

Use and Maintenance:

1. First Use: Choose Genuine Four-stroke Gasoline Engine Oil and Add It to the Engine Oil Tank, About 80ml. Replace It Every 100 Working Hours in the Future.

2. Fill the Fuel Tank and Engine Oil Tank with Gasoline and Engine Oil Respectively. Turn on the Oil Circuit Switch,

3. Open the Water Filling Cover Above the Water Pump. Fill up the Water Diversion, Use the Card Link to Connect the Water Inlet Pipe (Note That All Connections of the Water Inlet Pipe Cannot Leak. Air Leakage Will Cause the Water to Be Unable to Absorb).

4. Close the Damper and Pull the Starter. After Starting, Open the Throttle and Increase the Throttle to Start Working. (If There Are Signs of Starting but Failed to Start, Please Open the Damper and Continue to Pull the Starter)

Note: After Each Work, Run at Idle Speed for 2-3 Minutes, and Turn off the Engine After the Engine Temperature Drops to Increase the Service Life.

Packing List:

1x Pump

Hose Clamps and Accessories

Manual