TinyS3 (ESP32-S3 Board, u.FL Connector)

• The tiny, mighty ESP32-S3 development board in the TinyPICO format!
• It's packed with amazing features and peripherals, wireless connectivity, and stacks of Flash and PSRAM, all in the same tiny package size as the original TinyPICO!
• Each TinyS3 ships with a UF2 bootloader and the latest version of CircuitPython that supports the ESP32-S3.
• Ships with a set of male headers and JST connector that you can solder on if required.
• PLEASE NOTE: This version contains a u.FL connector instead of an on-board antenna. This board is designed to be used with an external antenna.

Technical Specifications
– 32Bit Dual Core 240MHz
– RISC-V Ultra-Low Power Core
– 2.4GHz Wi-Fi – 802.11b/g/n
– Bluetooth 5, BLE + Mesh
– 8MB QSPI Flash
– 8MB Extra QSPI PSRAM
– USB-C Connector
– Reverse USB Back-Feed Protection
– 700mA 3.3V LDO Regulator
– Ultra-Low Deep Sleep Current
– Low Power RGB LED
– VBAT Voltage Check + 5V Presence Detection
– LiPo Battery Charging
– JST Pads on Back Supports PH Connector
– Power (Red), Charge (Orange) LEDs
– 17x GPIO Broken Out
– USB Serial JTAG
– 3D High Gain Antenna
– Compatible with TinyPICO and TinyS2