Waveshare ESP32-S3 Development Board with 1.69inch Touch LCD Display,240×280

Waveshare ESP32-S3 Development Board with 1.69inch Touch LCD Display,240×280 Pixels 262K Color Micro LCD Display With ESP32-S3,Embedded with ST7789V2 Display Driver and CST816T Capacitive Touch Chip

• ESP32-S3 1.69inch Touch Display Development Board, 240×280 Pixels, Micro LCD Display With ESP32-S3, 262K Color,Embedded with ST7789V2 Display Driver and CST816T Capacitive Touch Chip
• Equipped with high-performance Xtensa32-bit LX7 dual-core processor, main frequency running up to 240MHz.
• Support 2.4 GHz Wi-Fi (802.11 b/g/n) and Bluetooth 5 (LE), and onboard antenna.
• Built-in 512KB SRAM and 384KB ROM, 8MB PSRAM, and external 16MB Flash.
• Onboard 1.69inch capacitive touch LCD screen, 240×280 resolution, 262K colors, can clearly display color pictures.

Introduction
ESP32-S3-Touch-LCD-1.69 is a cost-effective, high-performance microcontroller development board designed by Waveshare. On the small plates, onboard a
1.69inch capacitive touch LCD screen, Lithium battery charging chip, 6-axis sensor (3-axis accelerator and 3-axis gyroscope), and peripheral interface
such as RTC, easy to develop and embed into products.

Key features include:
Equipped with ESP32-S3R8 Xtensa 32-bit LX7 dual-core processor, up to 240MHz main frequency
Supports 2.4GHz Wi-Fi (802.11 b/g/n) and Bluetooth 5 (LE), with onboard antenna
Built in 512KB of SRAM and 384KB ROM, with onboard 8MB PSRAM and an external 16MB Flash memory
Type-C connector, keeps it up to date, easier to use
Onboard 1.69inch 240×280 pixels 262K capacitive touch display for clear color pictures
Built-in ST7789V2 display driver and CST816T capacitive touch chip, using SPI and I2C communication respectively, effectively saving the IO resources
Onboard QMI8658 6-axis IMU (3-axis accelerometer and 3-axis gyroscope) for detecting motion gesture, counting steps, etc.
Onboard PCF85063 RTC chip with reserved SH1.0 RTC battery header (supports charging) for RTC function requirement
Onboard RST, BOOT and a programmable PWM button for easy custom function development
Onboard 3.7V MX1.25 lithium battery recharge/discharge header
Reserved pads of 4 × GPIO, I2C, and UART interface, for connecting peripherals and debugging
Supports flexible clock, module power supply independent setting, and other controls to realize low power consumption in different scenarios
High touch screen transmittance, fast response and long lifetime

Development Resources
https://www.waveshare.com/wiki/ESP32-S3-Touch-LCD-1.69?Amazon

Package Content
ESP32-S3-Touch-LCD-1.69 x1