AUTOXBERT Battery Jumper Cable, 5M 500AMP 6AWG Heavy Duty Battery Jump Leads

AUTOXBERT Battery Jumper Cable, 5M 500AMP 6AWG Heavy Duty Battery Jump Leads Battery Starter with Zipper Carry Case Working Gloves Wire Brush for Car Van Truck (5M 500AMP 6AWG)

• Quality Materials: The outside of the battery jumper cable is made of soft rubber with full PVC coating, good insulation and flame retardant, high safety. The inner part is made of high quality thick copper wire, which ensures the stability of current passing and can be used for a long time
• Easy to use: Battery jumper cable red connects to the positive battery terminal, black connects to the negative battery terminal can be, alligator clips can firmly bite the battery terminals, easy to use
• Safe Design: High hardness metal crocodile clips, strong biting force, will not fall off, the handle is fully encircled by high quality soft rubber material, which provides an insulating and flame retardant effect to avoid leakage damage
• Practical Accessories: A zipped carry case makes it easier to store battery jumper cables, insulated gloves allow you to operate without risk of electric shock, and a terminal cleaning brush restores conductivity to connection contacts
• Widely Applicable: Jumper cables are used to start dead or undercharged 6V, 12V, 24V batteries and are suitable for most vehicles including cars, motorbikes, vans, trucks, SUVs, etc.

The connection procedure is as follows:
(1) First clamp the red wire of the start line above the positive pole of the red battery of the “rescue car”.
(2) Then clamp the red wire at the other end over the positive pole of the red battery of the “rescue car”.
(3) Clamp the black wire to the black negative battery of the “rescue car”.
(4) Then clamp the black wire to the black negative battery of the “rescue car”.
(5) Start the engine of the “rescue car” first, and then start the engine of the “rescue car”. If it is found that the rescued vehicle still cannot be started, please check if the metal contact part is in poor contact.
After the engine is started, it is still necessary to remove the start line in order, otherwise it may cause a short circuit.

The procedure for removing the line is as follows:
(1) First remove the “rescue car” black wire.
(2) We remove black wire of “rescue car” again.
(3) Then remove the red wire of the “rescue car”.
(4) Finally, the red wire of the “rescue car” is removed.

Instructions:
The battery line can be purchased in the auto parts market.
The battery line is usually black and red, which is mainly used to distinguish the positive and negative poles.
When you are riding a car, there is no need to start the vehicle on the electric side.
You only need to connect the batteries of the two cars in parallel.
The red line is added to the positive pole of the two cars,and the black line is connected to the negative pole of the two cars. The vehicle is gone.